The new rear bulkhead to cover the beerkeg fuel tank, made from 20mm box section frame with 1.5mm sheet steel panels.
After the frame, basic side panels were cut, these will need some small bits adding to go round the roll cage tubes.
With a bit of welding the drivers side is starting to feel quite solid.
The side ducts have been opened up and straightened to get a bit more air into the boot - just in case the hole in the floor isn't big enough ;-)
The passenger side before and after fitting the closing sections and welding to the cage.
Tidying things up with a spot of filler.
With the tank in place, all it needs now is a spot of paint, and a panel to bolt over the hole :-)
www.msefi.com
